Permatex® 81844 Professional Strength Rearview Mirror Adhesive

Permatex® Rearview Mirror Adhesive (Standard Strength) is a two part adhesive that permanently bonds metal mirror buttons to windshields. Achieves handling strength in seconds, and mirror mounting strength in 30 minutes. ODC free. OEM approved. Note: Permatex® Rearview Mirror Adhesive is not intended for bonding plastic buttons.

• 2-Part kit
• .3CC tube rear view mirror adhesive
• 2 minute bonding strength
• Fill gaps to .02"
• Moisture resistant
• Approved and used by GM, Ford and Chrysler
• Permanently remounts mirrors to windshields
• Achieves handling strength in seconds; mirror-mounting strength in 15 minutes
• ODC-free
• Not designed for plastic buttons
• Meets OEM specifications
• Carded.
• Mounting rearview mirrors to windshields.
• Easy to use
• Fast curing
• OEM factory service specified.
• All foreign and domestic metal rearview mirror mounting buttons.
• Remove the mounting button from the mirror bracket.
• On the outside of the windshield, mark the spot where the button was mounted with a felt-tip marker or crayon.
• Scrape all old adhesive off windshield and the button with a safety razor. (Be careful not to gouge button with razor.)
• Using fine grit sandpaper, put on a flat, hard surface and gently sand the mounting surface of the button using a circular motion.
• Open the Cleaner/Activator towelette by pulling both sides of the protective packet at a point at the top sides of the package. Fold the packet back to use. The towelette is attached to the foil packet. Do Not Remove.
• Apply the activator to the inside of the windshield where the spot has been marked by the felt-tip marker. Use a circular motion and make sure that the activator overlaps the mark by at least 1/2". Allow the activator to dry for at least 2 minutes. DO NOT TOUCH the glass after the activator has been applied.
• Tear open the adhesive pouch at the top or use scissors to cut open. Apply one drop only to the center of the button. (Remember, more is not better.)
• Immediately apply the button to the windshield, ensuring that the correct side is up (usually the rounded side). Hold firmly against the windshield for at least 1 minute. Do not move the button during this time. Allow to set for at least 30 minutes.
• Mount the mirror bracket onto the button. Clean off the marking on the outside of the windshield with alcohol.
• Wipe off any uncured resin with a cloth.
• Uncured resin may be cleaned up with a cloth saturated with alcohol.
• Clean hands with Fast Orange® hand cleaner.
• This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as an adhesive for chlorine or other strong oxidizing materials.
• Products shall be ideally stored in a cool, dry location in unopened containers at a temperature between 8 and 28 degree Celsius (46 and 82 degree Fahrenheit) unless otherwise labeled. Optimal storage is at the lower half of this temperature range. To prevent contamination of unused product, do not return any material to its original container.

Shipping calculated at checkout. Usually ships within 24 hours.

Not shipped to AK, AE, AA, AP, FM, GU, HI, MH, MP, PW, PR, VI.

Returns accepted within 30 days by mail. Return shipping is paid by the customer. See our refund policy.