Minwax® 61460 PolyShades® 1-Step Stain & Polyurethane Gloss Paint, Tudor, 1 Qt

$16.58

Created with Sketch.
Shipping charges calculated at checkout.
Created with Sketch.
Shipping not available to AK,AE,AA,AE,AE,AE,AP,FM,GU,HI,MH,MP,PW,PR,VI
4

Request a Bulk Quote

Thank you for your quote request. We will be in touch.

SKU: 10240894
MFG: 61460

Description

Minwax PolyShades combines beautiful wood stain and polyurethane in one simple step. Minwax PolyShades provides rich wood color and long lasting protection while enhancing the wood grain. It can also be used over polyurethane finishes, so you can change the color of your finished wood, without removing the existing finish.

  • Size: 1 Qt
  • Color: Tudor
  • Provides rich wood color & durable polyurethane protection
  • Combines beautiful wood stain and polyurethane in one simple step
  • Can also be used over polyurethane finishes, so you can change the color of your finished wood, without removing the existing finish.

Specifications

  • Sheens: Gloss
  • Location: interior wood surfaces
  • Dry time: 6 hours
  • Recoat: after 6 hours
  • Cleanup: mineral spirits
  • Coverage: 120-150 sq. ft. per quart
  • Coats: normally 2. Additional coats may be applied for richer color
  • Recommended uses: furniture, woodwork, doors, cabinets, accessories.

Surface Preparation

For Stripped, Unstained or Raw Wood

  • Before starting, surface must be dry, clean and free of dirt, grease and glue.
  • Sand the wood in the direction of the grain using fine-grade sandpaper (#220) until smooth.
  • Remove all sanding dust.

For Previously Stained Wood That Is Not Being Stripped

  • Before starting, surface must be dry, clean and free of dirt, grease and glue.
  • Lightly sand the wood to ensure adhesion. Remove all sanding dust.

Application

  • Using a natural bristle brush, dip approximately an inch into the can, gently tapping it against the inside to remove any excess. Apply a very THIN, even coat following the direction of the grain. Make sure to maintain a "wet" edge.
  • To minimize the brush marks and bubbles after staining, tip off the surface by holding the brush at a 45 degree angle and lightly run the bristles over the entire length of the wood.
  • Let the first coat dry for 6 hours or more. Dry time may be extended due to high humidity, low temperatures, and inadequate ventilation or if the coat is applied too thick.
  • Rub the surface lightly with fine steel wool (grade 000 or finer). Remove all dust. Brush on a second thin coat following directions above. To deepen the color, apply a third coat.

Coverage

  • Approximately 120-150 square feet per quart.

Cleanup

  • Use mineral spirits or paint thinner.

Warning

  • Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup. For more information, call the National Lead Information Center at 1-800-424-LEAD (in US) or contact your local health authority.
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Specifications

MFR:
61460
SKU:
10240894
UPC:
027426614604
Brand:
Minwax
Length:
4
Width:
4
Height:
5
Attachment:
MSDS Sheets,