Design Polymerics KK0326 Water Based Duct Sealant, 64 Oz

A fiber reinforced, water based, premium quality. For sealing joints, seams, and duct wall penetrations on metal air duct. UL listed 181A-M/B-M, high velocity duct sealant for commercial and residential supply and return air duct use.

• Size: 64 ounce
• Excellent workability
• Crack and peel resistant
• Mold and mildew resistant
• For sealing joints, seams, and duct wall penetrations on metal air duct
• For sealing connections on flexible duct or fiberglass duct board.
• Excellent dry adhesion
• Indoor and outdoor usage
• Minimal shrinkage
• Sag resistant
• Excellent water and U.V. Resistance
• Meets FDA, USDA, and EPA Standard
• UL Listed.

Directions:

Uses:

• DP 1030 may be used to seal joints on metal, flexible, and fiberglass duct board supply and return air duct.
• Surface Preparation:
• Surfaces should be clean, dry and free of dirt, oil and any foreign matter.

For sheet metal duct:

• DP 1030 should be applied to all connections according to SMACNA standards. Brush, caulk, pump, or trowel DP 1030 on all duct seams. Apply to TDC/TDF and applied flange corners. Apply to all penetrations in the duct wall including sheet metal screw heads and tie rods. When caulking DP 1030, sealant should be brushed into seams.

For round and oval spiral duct:

• Apply DP 1030 to the male section of the fitting or to the inside slip duct coupling. Secure with sheet metal screws per manufacturers requirements. Apply a 2" band of DP 1030 around outside of joint, covering all screws.

For rigid fiberglass air duct:

• Assemble sections according to the manufacturers recommendations. Apply a 3" by 20 mil band of DP 1030 to the joint. Embed a fiberglass scrim (5 mil, 20 x 10 plain weave, 1.75 oz per sq. yd.) in the sealant and apply another 20 mil coat of DP 1030 over the scrim.

For flexible duct:

• Install flexible duct per manufacturers instructions using drawbands or mechanical fastener. Apply DP 1030 at a rate of 80-90 sq. ft. per gallon (20-40 mils) between the end of the duct and the collar in a 2" band. Use DP 1030 to seal all connections of collar to metal duct or rigid fiberglass ductboard.

Pressure Testing:

• Allow at least 48 hours before pressure testing. Since temperature and humidity conditions may vary, longer cure times may be required for specific installations.

Technical Data:

• Chemical Family: Synthetic Latex
• Viscosity: Approx. 300,000 - 400,000 cps
• Application Temperature: 40 degree F - 110 degree F
• Storage Temperature: 40 degree F - 110 degree F
• Service Temperature: -25 degree F - 200 degree F
• Flammability: Non-flammable wet or dry
• Flash Point: No flash to boiling

Coverage:

• Dependent on application thickness, 80-90 sq. ft. at 20-40 wet mils

Clean Up:

• Use warm water and soap.