Superdeck DPI019025-20 Oil Exterior Transparent Stain, Red Cedar, 5 Ga

Superdeck® Transparent Stain is a high solids wood finish developed to give superior protection and beautiful color to exterior wood. Transparent Stain uses the highest quality pigments to inhibit damage caused by the sun, a three oil system to provide superior protection and is formulated to resist growth of mildew and algae on the coating’s surface. Product will not track and is resistant to foot traffic patterning.

• Size: 5 gallon
• Color: Red cedar
• VOC 250
• For decking or siding
• ONE COAT coverage with a transparent finish that highlights the wood grain
• Three oil formula contains deep penetrating tung oil for long lasting protection
• Highest quality iron oxide pigments to create long lasting colors and inhibit UV damage caused by the sun
• Formulated to resist growth of mildew and algae on the coating’s surface
• Excellent water repellency
• For use on any exterior wood substrate
• Made in the USA.

Uses:

• All exterior wood including redwood, cedar, pine, pressure treated wood and more.

Surface Preparation:

• All surfaces must be clean, dry, and free from dirt, mildew stains, dust and other foreign matter. Do not apply over sealed surfaces. Remove surface stains, dirt and failed oxidized stains with Superdeck® Wood Cleaner. Remove solid stains or paints with Superdeck® Wood Stripper. For redwood and cedar, follow cleaning or stripping with Superdeck® Wood Brightener to remove tannin stains and brighten wood to its original color. For new wood remove mill glaze with Superdeck® Wood Brightener.

Warning:

• Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead. Exposure to lead dust or fumes may cause brain damage or other adverse health effects, especially in children or pregnant women. Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment, such as a properly fitted respirator (NIOSH approved) and proper containment and cleanup.

Product Preparation:

• Product should be shaken or stirred before and during application. When using more than one container of product, intermix all product and stir well to ensure color consistency.

Thinning:

• Do not thin.

Application Methods:

• Product may be brushed, rolled or sprayed. If sprayed, use the lowest possible pressure needed for a reasonable spray pattern. Back rolling is suggested when spraying, working the product smoothly and evenly into the wood. This will decrease the possibility of pools or puddles on the surface and ensure a properly penetrated finish.

Application:

• Different wood species, textures and natural color will affect finished shade. Always test a small area first for color satisfaction before coating entire project. Apply at a rate the wood will absorb. Do not pool or puddle product on surface. Excess product allowed to sit on surface will result in a tacky finish and extended dry time. Remove tacky finish with a mild solution of Superdeck® Wood Cleaner after 24 hours. When properly applied, the wood surface will have a positive dry and the wood fibers beneath the surface will maintain excellent lubrication. Thoroughly coat the porous ends of all boards with product.

Number Of Coats:

• One coat depending on wood porosity and wood moisture content.

Application Temperature:

• 40° F.–95° F. Do not apply if wood surface is hot to touch or if rain is likely to occur.

Dry Time @ 77° F:

• 8 hours to touch, 24 hours for traffic; depending on weather conditions.

Spread Rate:

• Approximate spread rate: Smooth Surfaces: 250–350 sq. ft./gal.; Rough Sawn: 150–250 sq. ft./gal.

Clean Up:

• Clean brushes and equipment with mineral spirits or paint thinner following product manufacturer’s directions. Dispose of empty container or unused portion in accordance with local, state, and federal regulations.