Fram TG3387A Tough Guard Spin On Premium Oil Filter

Engineered for premium conventional and synthetic blend motor oil. Synthetic-blend filter media technology provides protection for oil change intervals up to 10,000 miles1. 99% filtration efficiency2

• Tough Guard®
• Spin On
• Provides superior engine protection
• Uses a 9% higher level of synthetic media to provide 6 times more engine protection
• 99% dirt trapping efficiency
• Silicone anti-drainback valve holds a reserve of oil in the filter to help protect the engine during start ups

Technology:

• Ordinary filters use only cellulose media, but tough guard adds microscopic synthetic fibers, creating small windows that trap the microscopic dirt particles without affecting the flow of oil
• Blending synthetic fibers with cellulose increases a filter's dirt-trapping efficiency and its dirt-holding capacity for higher levels of engine protection and longer filter life
• Tough guard is the perfect filter for drivers who push their vehicles in stop and go traffic, towing and extreme weather conditions

Installation Instructions:

• Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot
• Place a drain pan under the oil filter and unscrew oil filter
• Clean mounting base making sure the "o" ring from the old filter is not stuck to the filter mount
• Apply film of clean oil to filter gasket. Do not use grease
• Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers
• Check owner's manual for correct oil specification, viscosity and amount
• Add oil to "full" on dipstick. Idle engine for five minutes and check for leaks
• Shut off engine and recheck oil level after 5 minutes and top off as necessary.