Fram® PH3985 Extra Guard® Oil Filter
Description
With an ideal balance of dirt-trapping efficiency and dirt-holding capacity, Fram® Extra Guard oil filters use a special blend of fibers and resin to create a proprietary filter media that delivers excellent engine protection. Extra Guard is the perfect filter for everyday drivers who perform frequent maintenance on their vehicles.
- Canadian tire oil filter
- Engineered for Conventional Motor Oil
- Cellulose and Glass blended media provides protection for oil change intervals up to 5,000 miles1
- 95% filtration efficiency2
- Fits 88-87 american motors, 95-90 chevrolet, 92-90 dodge, 87-85 dodge truck, 92-88 eagle, 93-85 jeep truck, 87-85 mitsubishi truck, 91-81 peugeot, 87-84 renault & winnebago.
Installation Instructions:
- Use proper protective gear. Used motor oil should not come in contact with bare skin. Engine oil may be hot
- Place a drain pan under the oil filter and unscrew oil filter
- Clean mounting base making sure the "O" ring from the old filter is not stuck to the filter mount
- Apply film of clean oil to filter gasket. Do not use grease
- Screw new filter on until gasket reaches base contact. Then tighten according to instructions on filter using tightening guide markers
- Check owner's manual for correct oil specification, viscosity and amount
- Add oil to "full" on dipstick. Idle engine for five minutes and check for leaks
- Shut off engine and recheck oil level after 5 minutes and top off as necessary.
1 Follow recommended change intervals as noted in your vehicle owner's manual
2 Fram Group testing of average filter efficiency of PH8A, 3387A, and 4967 or equivalent Fram TG or XG models under ISO 4548-12 for particles greater than 20 microns
3 Where applicable.