Loctite® 1390603 PL® 200 Projects Multi Purpose Construction Adhesive,

Loctite® PL® 200 Projects Construction Adhesive is a premium grade adhesive for paneling, drywall and other light construction, inside or outside. The low VOC formulation meets stringent State and Federal VOC Regulations.

• 10 Oz
• Ultra low VOC content
• Meets all stringent Federal and State VOC regulations
• Water-based adhesive
• Non-flammable, environmentally friendly, non-toxic
• Low odor
• Great for indoor projects – no strong solvent odor
• Bonds to most building materials
• Provides a strong, durable bond to multiple surfaces
• Gap filling
• Will bridge minor gaps when bonding irregular surfaces
• Easy cleanup with water (uncured adhesive)
• Eliminates the use of harsh cleaning chemicals
• High grab
• Reduces nailing and fastener requirements by up to 50%.

Recommended For:

• Bonding drywall to concrete or block walls; drywall to drywall lamination; or paneling and FRP
• Providing a strong, flexible bond, on drywall, wood paneling and wood or metal studs.

Not Recommended For:

• Use on mirrors and metals that will corrode
• Bonding two non-porous surfaces
• Polyethylene, polypropylene, Nylon™ or Teflon™
• Applications requiring temperature resistance greater than 170°F (77°C)
• Exterior applications where rain is expected within 24 hours
• Underwater applications or permanent water immersion
• Cement Board (Durock™).

Directions:

Safety Precautions:

• Interior applications require ventilation to the outside during application and cure. Wear gloves. Wash hands after use.

Preparation:

• The temperature of the product, the surfaces and the working area must be above 40°F (4°C) and below 100°F (38°C). For best performance, apply adhesive at 70°F (21°C). Ensure surfaces to be bonded are clean, dry, structurally sound and free of dust, grease, oil, and other foreign contaminants. Precut and fit materials before applying adhesive. Cut off tip of cartridge in an ''X'' cutting method, cutting both sides of the nozzle. Puncture inside seal of cartridge.

Application:

• Using a caulking gun, apply a continuous bead of adhesive to all furring strips, studs and top and bottom plates. Position pre-fitted panels. Follow the nailing schedule for adhesives nail-on attachment per the Gypsum Association Manual. If installing panels to drywall, apply adhesive in a zigzag pattern within 1 inch of vertical edges on each side and two vertical beads in the panel center, 16 inches apart. Use mechanical fasteners at top and bottom to hold panel in place. Warped or bowed panels should not be used.

Cleanup:

• Clean tools and uncured adhesive residue immediately with warm water and soap. Cured adhesive may be carefully cut away with a sharp edged tool.