Loctite® 1716815 Stik'n Seal® Outdoor Adhesive, Crystal Clear, 1 Oz

Loctite® Stik'n Seal® is a versatile high-performance adhesive sealant formulated for all-purpose projects and repairs. This semi-flexible crystal-clear adhesive is designed to address the daily needs of the homeowner, both indoor and outdoor.

• 1 Oz
• Great for everyday projects and repairs
• Dries crystal clear
• Eliminates obvious bond lines achieving invisible repairs
• Thick gel-like consistency, will not run or drip; reduces clean-up
• Dries to a semi-flexible bond
• Ideal for bonding flexible materials such as fabric or leather
• Gap filling, will fill and seal uneven surfaces
  
• Formulated for all purpose projects & repairs
• Semi-flexible crystal clear adhesive is designed to address daily needs of homeowner both indoor & outdoor.

Recommended For:

• At least one surface should be porous
• Bonding aluminum, brick, cardboard, ceramic, fabric, fiberglass, glass, leather, rubber, steel, wood and most plastics

Not recommended For:

• Potable water systems
• Bonding two non-porous surfaces
• Bonding hard to bond plastics such as polyethylene and polypropylene    

Safety precautions:

• Wear gloves. Wash hands after use. For interior applications, use in a well ventilated area.

Directions:

Preparation:

• Protect work area. Surfaces to be sealed or bonded must be clean and free from grease. For improved adhesion, roughen very smooth surfaces. Pre-fit all materials before applying product. Pierce tube with the point on the reverse end of cap.

Application:

Tools typically required:

• Tooling device.

As an adhesive:

• Apply adhesive to both surfaces to be bonded. Wait for 5 minutes until adhesive is tacky and then press surfaces together. Clamp if necessary. Sets in approximately 10 minutes and dries in 24 hours. Dry time is dependent upon temperature, humidity and amount of adhesive used.

As a sealant:

• Apply a layer 1/4' (6 mm) thick bead over the area to be sealed. Tool if desired. Let dry for 24 hours. If necessary apply a second coat.

Cleanup:

• Clean tools and uncured product residue immediately with mineral spirits or acetone. Cured product may be carefully cut away with a sharp-edged tool.