Valspar 82390C Wet Look High Gloss Sealer, 3.7 Litres

Valspar Wet Look High Gloss Sealer waterproofs and enhances the colour and design of aggregate, masonry, brick, slate, and pavers with a glossy, wet-look sheen. The heavy-duty resin formula protects sun's powerful rays, damaging weather, water, petrol, and de-icing salts.

• Size: 3.78 Litre
• Flash Point: 205 deg F
• Application Temperature – 50-90 °F
• Impart a rich, glossy finish
• Clear, waterproofing sealer for driveways, sidewalks, pavers and patios
• Protects from sun, water and household-chemical damage
• Resists gasoline, oil and de-icing salts
• For use over semi-transparent stain or bare concrete.

Where To Use

• Exterior aggregate, concrete, brick, pavers, masonry, mortar and flagstone. Do not use on garage floors.

Note

• This product will seal out water and other stains, but will not correct moisture problems coming from within the surface. Test for moisture by taping aluminium foil or plastic wrap to the surface for 24–48 hours. If the surface is damp when the aluminium or plastic is removed, moisture migration is present. The source of the moisture must be corrected before using this product or it may turn white upon drying. General: All surfaces must be clean, dry, and free of all loose, peeling paint, or contaminants. Wash all surfaces, rinse well, and allow to thoroughly dry overnight before applying. Bare concrete: Allow 60 days minimum for new concrete to cure before sealing. Previously sealed surfaces: Clean with an all-purpose cleaner (TSP or substitute). Previously sealed surfaces must be porous and able to accept additional sealer. Test surface porosity before sealing: Avoid using this product on nonporous, sealed surfaces. To test, place a few drops of water on the surface. If water sinks in, the surface is porous enough to use this finish. If water remains on the surface, do not use.